PreciseFit 45-0309-062 Manual Del Usuario página 9

39. Place two 5/8" flat washers separated by a long spacer
tube onto the shaft. See figure 20.
(CC) LONG SPACER TUBE
(T) 5/8" FLAT WASHER
FIGURE 20
40. Place a spike disk and a short spacer tube onto the shaft.
Fit the short spacer tube onto the ends of the flanged
bearings in the spike disk and in the end plate. Push the
shaft on through the flanged bearing in the end plate.
See figure 21.
FIGURE 21
SPIKE DISK
(BB) SHORT SPACER TUBE
ENGLISH
41. Place one or two 5/8" flat washers onto the end of the
spike disk shaft and secure the shaft with a 1/8" x 1-1/2"
cotter pin. See figure 22.
42. Fasten the two drive disks to the shaft using two 1/8" x
1-1/2" cotter pins. See figure 22.
(T) 5/8" FLAT
WASHER
FIGURE 22
43. Remove the connecting link from the chain and then
assemble the chain onto the two sprockets on the left
side of the hopper. Fasten the ends of the chain together
using the connecting link. See figure 23.
44. Place the chain cover over the chain and fasten it to the
hopper end plate using two self tapping screws. See
figure 23.
(X) CHAIN
CONNECTING
LINK
FIGURE 23
9
(U) 1/8" x 1-1/2"
COTTER PIN
DRIVE DISKS
(J) SELF
TAPPING
SCREW