PreciseFit 45-0309-062 Manual Del Usuario página 5

8. Fasten the hitch tubes together using three 5/16" x
2-1/4" hex bolts and 5/16" nylock hex nuts. Do not
tighten yet. See figure 4.
(B) 5/16" x 2-1/4"
HEX BOLT (3)
FIGURE 4
9. Assemble the hitch brackets to the hitch tubes using two
5/16" x 2" hex bolts and 5/16" nylock hex nuts. Do not
tighten. See figure 5.
10. Assemble the hitch pin through the hitch brackets and
secure with the hair cotter pin. See figure 5.
IMPORTANT: Do not collapse the flat ends of the hitch
tubes when tightening the bolts in the next step.
11. Tighten, but do not overtighten the two 5/16" x 1-1/2"
hex bolts assembled in steps 2 and 3.
Tighten, but do not overtighten the two 5/16" x 1-3/4"
hex bolts assembled in steps 5 and 7. The lift handle must be able to pivot.
Tighten the hex bolts assembled in steps 8 and 9.
(M) 5/16" NYLOCK
HEX NUT (2)
FIGURE 5
12. Assemble a 1/2" flat washer, a wheel, another 1/2" flat
washer and then a 1/2" jam nut onto a 1/2" x 4" hex bolt.
Tighten the nut finger tight and then back off 1/4 to 1/2
turn. See figure 6.
13. Assemble the bolt and wheel to the transport tube using
a 1/2" nylock jam nut. Tighten the nut but don't collapse
the tube. See figure 6.
(M) 5/16" NYLOCK
HEX NUT (3)
(C) 5/16" x 2"
HEX BOLT (2)
(II) HITCH PIN
(W) HAIR COTTER
PIN (1/8")
ENGLISH
14. If the wheel does not spin freely, back off the nylock jam
nut and then the plain jam nut 1/4 to 1/2 turn each.
15. Assemble a wheel to the other side. See figure 6.
TRANSPORT
TUBE
(S) 1/2" FLAT
WASHER
(A) 1/2" x 4"
HEX BOLT
FIGURE 6
16. Screw a 1/4" hex nut all the way onto the flow control
link. Assemble the ferrule onto the link and then start a
1/4" nylock hex nut one or two turns onto the link. See
figure 7.
17. Assemble the ferrule into the hole at the end of the flow
control lever using a 1/4" nylock hex nut. Tighten the
nut, leaving it loose enough that the ferrule can pivot.
See figure 7.
18. Assemble the grip onto the end of the flow control lever.
See figure 7.
(L) 1/4" NYLOCK
(EE) FERRULE
(DD) FLOW
CONTROL
FIGURE 7
5
(O) 1/2" NYLOCK
JAM NUT
(N) 1/2" HEX
JAM NUT
(FF) GRIP
FLOW
CONTROL
LEVER
HEX NUT
(L) 1/4" NYLOCK
(K) 1/4" HEX NUT
LINK
HEX NUT