PreciseFit 45-0309-062 Manual Del Usuario página 7

HINT: In the next two steps, place the bearing on a flat
surface and press the disk down onto it.
29. Install two flange bearings into each of the drive disk
assemblies. See figure 11.
DRIVE DISK
ASSEMBLY
(Y) FLANGED
BEARING
FIGURE 11
30. Install a flange bearing into the flat side of each spike
disk, as shown in figure 12.
SPIKE DISK
FIGURE 12
31. Install flanged bearings into both of the end plates. See
figure 13.
32. Place the 1/4" thick spacer onto the spike disk shaft
and then insert the shaft through the flanged bearing in
the left hand end plate. See figure 13.
(Y) FLANGED
BEARING
FIGURE 13
(Y) FLANGED
BEARING
(Y) FLANGED
BEARING
(Y) FLANGED
BEARING
(AA) 1/4" THICK
SPACER
SPIKE DISK SHAFT
ENGLISH
33. Place a short spacer tube, a drive disk, a 5/8" flat washer, another drive disk and a second 5/8" flat washer onto the
shaft. Fit the short spacer tube onto the flanged bearing
in the end plate. See figure 14.
FIGURE 14
IMPORTANT: The necks of the spike disks in the following
assembly instructions must face toward each other.
34. Place two spike disks, separated by a long spacer tube,
onto the shaft. Fit the long spacer tube onto the ends of
the flanged bearings in the disks. See figure 15.
(CC) LONG SPACER TUBE
FIGURE 15
7
DRIVE DISKS
(BB) SHORT SPACER
TUBE
(T) 5/8" FLAT WASHER
SPIKE DISK