Using Channel Scan; Reassigning Device Keys - RadioShack Kameleon 4-in-1 Manual De Instrucciones

USING CHANNEL SCAN

In all modes except DVD, use FAV SCAN to start a 3-second scan of all
favorite channels (if programmed – see Programming Favorite Channel Scan
on the previous page) and/or all channels for the selected mode.
1. Press VCR, TV, or CBL/SAT once (for the device you want to channel scan).
The bottom IR segment flashes once as the selected device key animates.
2. Press FAV SCAN once. The IR segments will animate as each channel
is changed.
• If Favorite Channel Scan has been set up, scanning of favorite channels
will start and cycle through stored channels for 3 minutes or until
stopped by pressing any key.
• If Favorite Channel Scan has not been set up, scanning will start with
the current channel, then proceed to the next channel up and cycle
through all channels for 3 minutes or until stopped by pressing any key.
3. To stop scanning channels at any time, press any key once.

REASSIGNING DEVICE KEYS

The RadioShack 4-in-One Remote can be set to control a second device. For
example, to control a TV, a Cable Box, and two DVD Players, you can reassign
the unused VCR key to operate the second DVD Player as follows:
1. Press and hold P until the bottom IR segment flashes twice. The program
keys will appear:
2. Press above MODE once. The Mode Mover programming screen will appear:
3. For the source mode, press a device key once (i.e., VCR, TV, CBL/SAT, or
DVD). For this example, press DVD once. The selected device menu screen,
including
NOTE: Only one device can be assigned to an unused device key at a time.
4. For the destination mode, press a device key once (i.e., VCR, TV, CBL/SAT, or
DVD). For this example, press VCR once. The bottom IR segment will flash
twice to confirm reassignment. The program keys will appear again.
22 Using Channel Scan/Reassigning Device Keys
4- -O
IN NE
, will be displayed.
R P
EMOTE OWERED
B K
Y AMELEON