Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3
10 mn
Filtering
and
robot
working for 10 minutes, your immersion
detector is monitoring (green indicator light
flashing) and must not set off the alarm..
5
x5
The
siren
must
sound
maximum of 12 seconds after the fall. Stop
the siren using the magnet.
You must always perform additional fall tests at different locations in the pool (including
steps) as per the procedure described above.
After each fall, allow your immersion detector to be automatically reactivated before the
next fall. Depending on wind and pool disturbance conditions, this reactivation may take
about ten minutes.
Warning: when your device switches out of TESTS mode (specific tune), the siren
of your immersion detector will sound at full volume. You can reactivate the TESTS
mode for an extra 30 minutes: to do this, please refer to item 4.5.
If one of these tests fails:
I
Look up item 5.
Contact your retailer for advice.
I
I
Check with the AstralPool After Sales Service at +34.93.713.63.44.
Send a letter to the AstralPool technical department, clearly describing your problem, and leaving
I
your details at the following address:
cleaner
a
AstralPool SAU
Avda Francesc Macia, 38 Planta 18
08208 Sabadell – Spain
10
4
With the filtering system and robot cleaner
working, drop the 6 kg weight from the top
of the coping, from the point furthest away
from your immersion detector.
6
x1
Wait for the automatic restart
(green indicator light flashing). This may
take about ten minutes.
Tabla de contenido
