Handicare SIMPLICITY Manual De Instalación página 5

Figure 8
Figure 9
Figure 10
c At the top end of the top section use a
hacksaw to remove the excess plastic
carrier strip (Figure 6).
d Carefully replace the charge spring contact.
4 Position the top section of track adjacent
to the bottom section of track (Figure 7).
5 Offer up the adjacent track section in the
normal way. Run the two core top safety
edge/end cap cable to the top of the track.
Bolt together the two track sections as normal.
6 Bolt both sections of track together (Figure 8).
The bolts should be tightened in sequence:
a left bottom
b centre bottom
c right bottom
Repeat this process until the bolts are all secure
(torque setting 8-9Nm).
7 Push the plastic carrier strip down from the
top track section to meet the plastic carrier
strip in the bottom section. The plastic carrier
strip will finish 10mm short of the end of the
track. Carefully feed down the copper charge
strip (Figure 9) and trim to the same length
as the plastic carrier strip.
8 Check that the charge strip has made proper
contact with the spring contact at the bottom
of the track (Figure 4).
Note: Ensure that the track is connected
with all faces level so that no step is present
in the joint.
Note: Excessive force can damage and
prevent the spring contact from making
a proper connection.
9 Slide the three mounting feet on to the track
(Figure 10).
Note: See page 8 for Slide Track positioning.
HANDICARE SIMPLICITY INSTALLATION MANUAL 5
Track assembly
d left top
e centre top
f right top