Remove The Shoe; Operation; Start The Machine; Stop The Machine - Powerworks XB 20V Manual Del Operador

EN
5.7

REMOVE THE SHOE

1. Loosen the shoe release screw with a hex wrench.
2. Pull the shoe from the machine.
6

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
6.1

START THE MACHINE

1. Push the lock-out button to the left or right side to
unlock the switch trigger.
2. Pull the switch trigger.
Before you use the machine, wait until the blade gets
to fully speed.
6.2

STOP THE MACHINE

1. Release the switch trigger.
WARNING
WARNING
I
O
WARNING
English
6.3 ADJUST THE ANGLE OF THE
SHOE
1. Loosen the screw with the allen wrench.
2. Move the shoe to the necessary angle.
3. Tighten the screw.
6.4

OPERATE THE MACHINE

1. Clamp the work piece.
2. Rest the front shoe of the saw on the work piece.
3. Start the saw on the work piece.
Make sure that the blade is not contacting the work
piece.
Flush cutting
1. The compact design of the machine permits
close cutting to floors, corners and other difficult
areas.
2. To maximize flush cutting capabilities, insert the
blade shaft into the blade clamp with the teeth of the
blade facing up.
3. Turn the saw upside down so you are as close to
the work surface as possible.
Wood cutting
8
NOTE