Glass 1989 SPA Manual De Uso página 64

NOTE:
active in both ranges.
MODE:
"READY" MODE - "REST" MODE
EN
"READY" mode:
pump to maintain the water at the set
temperature ("polling" function).
"REST" mode:
allows the water to heat only during the
NOTE: during this mode, as the "polling"
process is not active, the display
temperature is viewed after a few minutes
from the pump activation.
Recirculation mode:
the heater is continuously active. This
way, the temperature of the spa is always
constant as in the"READY" mode, without
SET TEMPERATURE RANGES
MAIN SCREEN
" " ->"
HIGH RANGE
pass to the subsequent parameter
of the "MAIN MENU"
Main screen
Press temperature keys to change the value
"
LOW RANGE
select the "RANGE" arrow
on the display
Or wait
a few seconds
Press temperature keys to change the value
"polling".
The main screen shows "RUN" "PUMP"
"FOR" "TEMP"
pump is not active for more than one hour,
whereas it remains unchanged during the
used.
"
when the Spa is programmed in "REST"
mode and the "JETS" key is pressed. In
this event the Spa must be used and must
heat up to the set temperature. After one
NOTE: This mode can be changed by
accessing the mode menu and changing
mode.
TIME:
SET CURRENT TIME
DISPLAY TIME
Setting the time is important to determine
the system.
To set the current time of the day: access
the "TIME" menu, if the "TIME" parameter
time is already set in the memory.
Or wait a
few seconds
set
Or wait
a few seconds
16
" appears on the display