Glass 1989 SPA Manual De Uso página 54

AIR CONTROLS MAINTENANCE
become lodged inside the valve body. It is very important that this debris is removed as
soon as possible to avoid damage to the valve. To accomplish this, follow this procedure:
1.Put the installation on/off switch to off.
EN
rotating, use a little extra force to rotate the face even more counter-clockwise past the
locking position until it stops. Pull face with the body away from the spa
4.Wipe the valve body and the interior walls of the valve clean.
5.Lubricate the o-rings with a waterproof lubricant available from your dealer.
JETS MAINTENANCE
If you notice that the jets spins slower than when the spa was new, or the jets are sticking,
the cause could be a build-up of deposits inside the jets. To remove the deposits, use
the following instructions:
1. With the spa off, rotate the jet face counter-clockwise until it stops.
counter-clockwise past the locking position until it stops. Pull face with the body away
from the spa.
spin very freely. If it does not, place the bearing end in a cup of vinegar (the vinegar
repeat the spin test.
jet still does not spin, you will have to purchase a new bearing from your dealer.
overcome the locking position. If the face does not rotate, remove and rotate face
body 180°and repeat this step. Turn the pump on, the jet should spin freely.
CARE OF THE SPA PILLOWS
The spa pillows will provide years of comfort if treated with care. They have been
positioned above the water level to minimize the bleaching effects of chlorinated water
and other s pa water chemicals. To extend their life, whenever the spa shell is being
cleaned, the spa pillows should be removed and cleaned. Body oils can be removed
remove any soap residue. If the spa is not going to be used for a long period of time(that
is during a vacation or if the spa is winterized), or when the spa water is being super-
chlorinated, the spa pillows should be removed until the next use of the spa.
To remove and replace the spa pillows:
6