Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY TOOLS REQUIRED
Hex wrench (supplied)
ASSEMBLY TIME ESTIMATE
15 to 30 minutes
STANDARD EQUIPMENT
Four sections of the height rod (A), and two mortise bits (B) are furnished (Fig. 1).
B
ASSEMBLY OF BASE UNIT
The unit is shipped with the crank handle disassembled.
Remove the bolt and washer (B and C) Fig. 2. Place
the crank handle (D) on the crank shaft (A) with the
crank knob facing out and the "D"-shaped hole in
handle aligned with the flat on the shaft. Place the bolt
(C) through the washer (B) and thread it into the shaft
(A). Tighten securely.
ASSEMBLY OF MOTOR UNIT
To reduce the risk of injury, turn
unit off and disconnect it from power source
before installing and removing accessories,
before adjusting or when making repairs. An
accidental start-up can cause injury.
1.
In the hardware package, locate the two cap
screws, two flat washers, and a 5/32" (4.0 mm) hex wrench. Place the washers
on the cap screws.
2.
Insert the splined cutter shaft (Fig. 3) through the motor carriage (L) and into the
spiral grooved bushing (M) in the main frame (N). Orient motor as shown in Fig. 8
and seat it into the motor carriage.
3.
Insert the two screw and washer assemblies (from Step 1) through the motor
carriage (Fig. 4). Thread them into the holes in the motor housing. Tighten
securely with the hex wrench.
N
M
FIG. 3
ASSEMBLY
L
SCREWS & WASHER
7 7
A
FIG. 1
A
B
C
D
FIG. 2
FIG. 4
Tabla de contenido
