Drop Ceiling Mount - Axis Q60 Serie Guia De Instalacion

6. Turn the cable holders to keep the cables in place.
7. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
8. Slide the unit holders on the network camera into the slots in the mounting plate and
rotate the camera unit.
9. Install the supplied midspan. See page 25.

Drop Ceiling Mount

WARNING
The combined weight of the camera and ceiling mount is approximately 3200 g (7.1 lb.).
Make sure that the ceiling material is strong enough to support this weight.
NOTICE NOTICE NOTICE
The ceiling tile should be 5–60 mm (0.2–2.4 in.) thick.
1. Remove the ceiling tile in which the drop ceiling mount is to be fitted.
2. Cut a hole in the ceiling tile for the drop ceiling mount. Use the supplied template to
mark the position and cut around the template.
1
Ceiling tile
2
Hole diameter 225 mm (8.9 in.)
3. Assemble the ceiling bracket and attach it to the ceiling tile. Make sure the arrows on
the mounting plate and the ceiling bracket are pointing in the same direction for the
logotypes on the camera and the trim ring to align.
4. Tighten the bracket arm screws.
5. Loosen the camera base lid screws and remove the camera base lid.
6. Route and connect the network cable and the multi-connector cable (sold separately), if
applicable, to the camera.
20
AXIS Q60 Series
1
2