Moving The Appliance; Electrical Or Electronic Product At End Of Service Life; Problems And Corrective Actions - Krups ESPRESSERIA AUTOMATIC PREMIUM Manual De Instrucciones

IFU display-GB hors tuv.qxd:Mise en page 1
Keep the packing and use it again to move the appliance.
If the unpacked appliance is dropped, it is advisable to take it back to an authorized service centre to avoid any
risk of fire or electrical problems.

ELECTRICAL OR ELECTRONIC PRODUCT AT END OF SERVICE LIFE

Let's all help protect the environment !
Your appliance contains many recyclable materials that can be recovered or recycled.
Leave it at a local civic waste collection point.
HELPLINE
If you have any product problems or queries, please contact our Customer Relations Team first for expert help and advice:
0845 330 6460 - UK
(01) 677 4003 - Ireland
or consult our website - www.krups.co.uk
The appliance does not switch on when the
"On/Off" is pressed.
Water or steam comes incorrectly out of the
steam nozzle.
The espresso or coffee is not hot enough.
The coffee is too light or not strong enough.
The coffee flows too slowly.
The coffee is not creamy enough.
The appliance does not serve any coffee.
You have used ground coffee instead of bean
coffee.
The grinder makes a strange noise.
The grinding fineness knob is hard to turn.
The steam does not come out of the nozzle.

MOVING THE APPLIANCE

PROBLEMS AND CORRECTIVE ACTIONS

Check that the plug of the power cord is pushed correctly into the mains
socket.
In case of repeated operation, several drops may drip from the steam noz-
zle.
Change the coffee temperature setting.
Heat the cups by rinsing them with hot water.
Check that the coffee bean tank has coffee in it and that it is flowing correctly.
Avoid using oily, caramelised or flavoured coffee.
Reduce the volume of coffee using the central knob.
Turn the grinding fineness knob towards the left for a finer grind.
Prepare in two cycles using the 2 cup function.
Turn the grinding fineness knob towards the right for a coarser grind (may
depend on the type of coffee used).
Carry out one or two rinsing cycles.
Turn the grinding fineness knob towards the left for a finer grind (may
depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the installation pro-
cedure on page 3).
Carry out one or two rinsing cycles.
An incident has been detected during the preparation. The appliance resets
itself automatically and is then ready for a new cycle.
Use your vacuum cleaner to suck out the pre-ground coffee in the coffee
bean tank.
There are foreign particles in the grinder.
Contact KRUPS' Customer Service.
Only change the grinder setting when it is operating.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed. Make sure the
steam nozzle is not clogged at the aerator (if necessary clean the steam
nozzle aerator with the needle supplied). Empty the tank and remove the
Claris filter. Fill the tank with mineral water high in calcium (> 100 mg/litre
or .015oz/gallon), it may take as many as 5 to 10 cycles of steam at 60
seconds each cycle to achieve a continuous jet of steam.
12
27/01/09 9:09 Page 12