Parts And Components - WAGNER RENUVO Manual De Usario

Herramienta para aplicación de tintura

Ocultar thumbs Ver también para RENUVO:

Manual del usuario (25 páginas)

Manual del usuario (24 páginas)

Tabla de contenido

Idiomas disponibles

Note: The graphic below shows the Renuvo

components as they are out of the box. Some

parts will have to be assembled prior to use.

See "Assembly" instructions, below.

Pad connection

Pad assembly

quick-release tabs

Pad assembly

Brushes

Assembly

Note: Depending upon how your Renuvo was

packaged, some assembly may be required. These

steps will only have to be performed once.

1. Remove the piece of tape that is stretched across

the top of the lower container assembly (a).

Note: A rod is located inside the tube of the lower

container assembly (e). After removing the tape,

make sure this rod does not slide out. If it does,

make sure it gets replaced with the large flange (b)

side going in first.

2. While holding in the snap buttons (c) on the

upper handle (d), slide the upper handle into the

lower container assembly (e).

3. Slide the upper handle down into the lower

container assembly until the snap buttons "click"

into the holes on the lower handle.

Note: The holes on either side of the lower

container assembly are different sizes. Make sure

the snap buttons in the upper handle are lined

up with the correct holes in the lower container

assembly.

iMpORTaNT: Once the Renuvo is assembled,

DO NOT attempt to disassemble the handle.

attempts to disassemble could permanently

damage the unit.

English