Technical Data; Installation Of Main Plug - simatherm IH 240 Manual De Instrucciones

2.2

Technical data

Voltage (± 9%)
Recommended circuit protection
Power consumption (maximum)
Temperature control
Probe maximum temperature
Time mode
Power reduction
Demagnetisation, automatic
Overall dimensions
Area between supports
Coil diameter
Weight (with yokes)
Workpiece maximum weight
Maximum heating temperature
Standard yoke dimensions
3

Installation of main plug

Due to the many types of mains plugs, no mains plug is supplied with
the IH 240. A qualifi ed electrician must install a suitable mains plug.
The correct supply voltage is shown in section 2.2. The wires should be
connected as follows:
Colour of IH 240 wire
yellow / green
brown
blue
Connect the IH 240 to only two of the three phases. Verify that the
correct cicuit breaker is installed. See section 2.2 for circuit breaker
specifi cations.
© simatec ag
400 V / 50 Hz (Art. 110.1601)
460 V / 60 Hz (Art. 110.1602)
63 A circuit breaker
24 kVA (400 V / 50 Hz)
24 kVA (460 V / 60 Hz)
0–250 °C, in steps of 1°
250 °C
0–60 minutes, in steps of 0.1minute
20 – 100% in steps of 20%
Residual magnetism < 2 A/cm
750 x 400 x 935 mm, IH 240
460 x 400 x 1120 mm, IH 240-L
330 x 355 mm, IH 240
460 x 505 mm, IH 240-L
186 mm
300 kg, IH 240
320 kg, IH 240-L
1200 kg
ca. 250 °C
100 x 100 x 570 mm, IH 240
100 x 100 x 700 mm, IH 240-L
(for
Mains supply terminal
ground
phase 1
phase 2
Induction Heater IH 240 / IH 240-L
of 142 mm)
Ø
21