Vehicle Lap Belt Only - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

NOTE: Do NOT install by this method for a child weighing
more than 30 lb (13.6 kg).
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing,
after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.
Installation with Vehicle Lap Belt Only
1. Place child restraint REAR-
facing on the vehicle seat
so that the car seat base is
flat on the vehicle seat and
is parallel to vehicle seat.
2. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
3. Ensure that no more than
3 in (7.6 cm) of the base
hangs over front edge of
the vehicle seat.
4. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
22
3 in 3 in