Eliminating Faults - Festo DGE-25-ZR-RF Instrucciones De Utilizacion

DGE−...−ZR−RF
11

Eliminating faults

Fault
Positioning not
accurate
Loud noises during
operation operation
Festo DGE−...−ZR−RF 0405a English
Possible cause
Tooth overrun due to excessive
inertial forces
Toothed belt damaged
Reference point switch loose or
switching cam loose
Outside the axis
Fastening of interface to workload
on the slide loose
Fastening of coupling loose
Play in roller guide
Defective bearing of shafts etc.
Roller guide damaged
Play in roller guide
Insufficient lubrication (of slide
bearing)
Toothed belt damaged
Outside the axis (e.g. drive
package including coupling or
external attachments)
Wear on drive shaft
Remedy
reduce the dynamic loading,
new reference travel, if
necessary return to Festo
Return product to Festo
Fasten
Check peripherals
(e.g. motor, controller, etc.)
Fasten again as described in
the chapter Fitting"
Tighten the coupling
Return product to Festo
Return product to Festo
Lubricate; if necessary
return product to Festo
Return product to Festo
Check peripherals to make
sure that parts are in
contact with each other
Return product to Festo
51