Recording; Recording A Tape On Deck A - JVC PC-X270 Manual De Instrucciones

Recording

IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the JOG VOLUME. Thus, during recording
you can adjust the sound you are actually listening to
without affecting the recording level.
• While recording, you can hear sound modes through the
speakers or headphones. However, the sound is recorded
without these effects (see page 9).
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can use only type I (Normal) tapes for recording.
To protect your recording
Cassettes have two small tabs on
the back to protect unexpected
erasure or re-recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
Pinch rollers
Capstans
Heads
To demagnetize the heads
Turn off the unit, and use a head demagnetizer (available at
electronics and record shops).

Recording a Tape on Deck A

On the unit ONLY:
1
Press STOP/EJECT 7/0 for the deck A.
2
Put in a cassette as shown below, with the
side you want to record on out and the
exposed part of the tape down.
3
Close the cassette holder gently.
4
Start playing the source — FM, AM*, CD
player, deck B, or auxiliary equipment
connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 16).
• When the source is deck B, you can also use the
dubbing method. (See "Dubbing Tapes" on page 16.)
* See "To record an AM station — Beat Cancel" on page 16.
5
Press REC ¶ for the deck A.
The recording starts.
To stop during recording, press STOP/EJECT 7/0 for
deck A.
To remove the cassette, press STOP/EJECT 7/0 for deck A.
– 15 –
REC