Approved Kombiengines; Mounting The Pole Pruner - Stihl HT-KM Manual De Instrucciones

English / USA

Approved KombiEngines

Only use KombiEngines supplied by
STIHL or expressly approved by STIHL
for use with the KombiTool.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHL KM 55 R, KM 55 RC, KM 90 R,
KM 85 R, KM 110 R, KM 130 R
The KombiTool may also be mounted to
STIHL brushcutters with a split boom or
drive tube (T models).
Operation of this KombiTool is therefore
also permitted on the following power
tool models:
STIHL FS 55 RT, FS 55 RTC, FS 85 RT,
FS 83 RT
16

Mounting the Pole Pruner

Mounting the Gearbox
Pull the protective caps off the ends of
the drive tube and keep them in a safe
place.
A
: Apply a mark to the drive tube at a
distance A of 50 mm (2").
2 1
: Push the gearbox (1) onto the drive
tube (2) as far as stop – turn the
gearbox back and forth until the
square end of the shaft engages.
The gearbox is correctly positioned if it
reaches or covers the mark (see arrow).
3
1
3
: Insert clamp screws (3) as far as
stop.
: With the engine is resting on the
machine support, line up the
gearbox (1) so that the clamp
screws face up and the chain
sprocket cover is exactly vertical.
: Tighten down the clamp screws (3)
in the following sequence:
– tighten the left screw moderately
– tighten the right screw moderately
– tighten down the left screw firmly
– tighten down the right screw firmly
HT-KM