Kohler K-8013 Guía De Instalación Y Cuidado página 8

4.
Install the Finished Wall
4-1/8" (10.5 cm) D.
Ø 4-1/8" (10,5 cm)
4-1/8" (10,5 cm) D.
Cutout
Découpe
Abertura
Install the water-resistant wall board.
Cut out a 4-1/8" (10.5 cm) round hole, centered on the pipe nipple at each desired
installation location.
Install the finished wall material.
Installer le mur fini
Installer le matériau du mur résistant à l'eau.
Découper un orifice rond de 4-1/8" (10,5 cm), centré sur le mamelon du tuyau à
l'emplacement d'installation désiré.
Installer le matériau du mur fini.
Instale la pared acabada
Instale el panel de yeso para pared resistente al agua.
Taladre un orificio redondo de 4-1/8" (10,5 cm), centrado en el niple en el lugar
deseado de instalación.
Instale el material de acabado de la pared.
5.
Install the Pipe Nipple
Remove the nipple.
NOTE: The minimum distance between the face of the tee/elbow and the surface of
the finished wall should be 2-1/4" (5.7 cm). The measurement for typical installations
is 2-7/8" (7.3 cm).
Measure the distance from the face of the tee/elbow to the surface of the finished
wall. Make any adjustments as needed.
If your measurement is between 2-1/4" (5.7 cm) and 2-3/4" (7 cm): Use a close
pipe nipple.
1080947-2-C
Tee (or Elbow)
T (ou coude)
T (o codo)
2-1/4" (5.7 cm)
4-1/8" (10.5 cm) D.
Min/Min/Mín
Ø 4-1/8" (10,5 cm)
4-1/8" (10,5 cm) D.
8
Finished Wall
Mur fini
Pared acabada
Cutout
Découpe
Abertura
Nipple
Mamelon
Niple
Kohler Co.