Technical Specification - Hallde RG-50S Instrucciones De Uso

INFORMATION: If the machine is left damp for
longer periods stains will appear. These stains
are harmless but the original surface will lose
its lustre. Vegetables and fruit contain acids.
Depending on which products are processed
this will have an effect on the metal after
varying periods of time. It is therefore important
to clean the machine immediately after proces-
sing salty and acidic products.
TROUBLE SHOOTING
To eliminate the risk of damage to the motor,
the RG-50S is fitted with thermal motor protec-
tion that automatically switches off the machine
if the temperature of the motor should become
too high. The thermal motor protection has
automatic reset, which means that the machine
can be started again when the motor has
cooled down, which usually takes between 10
and 30 minutes.
FAULT: The machine will not start or stops while
running and cannot be re-started.
REMEDY: Check that the power plug is
properly inserted in the wall socket or, alter-
natively, turn on the mains switch. Check that
the fuses in the wall box for the premises have
not blown and have the correct ampere rating.
Check that the vegetable preparation attach-
ment is correctly fitted and that the its handle
has been lowered. Wait for up to 30 minutes
and then try to start the machine again. Call in
a qualified service mechanic for action.
FAULT: Low capacity or poor processing result.
REMEDY: Select the right cutting tool. Always
use the ejector plate. Check that the knives and
cutting tools are whole and sharp. Press the
food down loosely with less force.
FAULT: The cutting tool cannot be removed.
REMEDY: Always use the ejector plate.
Use a thick leather glove or other glove that
the blades of the cutting tool cannot cut
through and remove the cutting tool by turning
it clockwise.

TECHNICAL SPECIFICATION

HALLDE RG - 50S
CAPACITY AND VOLUME: Processes up to
2 kg. per minute depending on the type of
cutting tool and foods. Volume of the feeder:
0.9 litres. Diameter of the feed tube: 53 mm.
MACHINE BASE: Motor: 1.0 kW. 120 V,
single phase, 50-60 Hz. 220-240 V, single
phase, 50/60 Hz. Thermal motor protection.
Transmission: Maintenance-free toothed belt.
Safety system: Two safety switches. Degree
of protection: IP34. Power supply socket:
Earthed, single phase, 10 A. Fuse in fuse
box for the premises: 10 A, delayed. Sound
level: LpA (EN31201): 76 dBA. Magnetic field:
Less than 0.1 microtesla. Speed: One speed.
Approx. 500 rpm.
CUTTING TOOLS The diameter of the cutting
tools is 185 mm.
4
NET WEIGHTS: Machine base: 8.6 kg. Feed
head: 1 kg. Cutting tools: approx. 0.3 kg
average.
NORMS/STANDARDS: NSF STANDARD 8,
see declaration of conformity.
HALLDE • User Instructions