Ferm RSM1019 Traducción Del Manual Original página 6

Checking and replacing the carbon brushes
Fig. A
The carbon brushes must be checked regularly.
If the carbon brushes are worn, the machine will
start to run unevenly.
Only use the correct type of carbon
brushes.
• Remove the carbon brush holders (6) using a
screwdriver.
• Clean the carbon brushes.
• In case of wear, replace both carbon brushes
at the same time.
• Mount the carbon brush holders (6) using a
screwdriver.
• After mounting the new carbon brushes, let the
machine run at no load for 15 minutes.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material.
Therefore please make use of options for
recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
6