Multiplex MULTImate V 1.42 Manual De Instrucciones página 39

9. M 8: S
ENU ERVOPROG
The MULTImate is suitable for programming HiTEC digital servos which can communicate with the programming
devices HFP10/20 and HPP-21, and also for programming all MULTIPLEX digital servos with digi 4 electronics or later
(with the exception of the POLO digi 4 and TITAN digi 4). However, not all settings are available; this varies according
to the servo type to be programmed.
• Connect the UNI lead attached to the HiTEC servos to the PC and Data port on one end of the MULTImate.
Action & Display
8 Servoprog.
8-1 Reverse
off
8-2 Deadband
1
8-3 Speed.
64
8-4 Failsafe
off
8-5 Positions
4
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
.
8 Go back
...to main menu
8-5 Go back **
...to Servo
8-5 Positions
Send data?
Explanation
Main menu display „8 Servoprog."
After : the MULTImate reads out the data for the
connected servo ("please wait ..." or "bitte warten...")
Setting the servo direction (reverse)
• Values: "on" / "off" or "ein" / "aus"
• To set the direction of rotation:
, then or , confirm with
Setting the servo dead-zone
•
Range of values: 1, ..., 16
•
To set the value: , then
Setting the servo transit speed
•
Range of values: 1, ..., 64
•
To set the value: , then
Fail-Safe settings
•
Values: "on" / "off" or "ein" / "aus"
•
To set the value: , then
Setting different servo positions
(Travels / Centre / Fail-Safe)
** Note: this menu point is only displayed if all the
parameters ("middle", "end 1", "end 2" and "failsafe" or
"Mitte", "Endp. 1", "Endp. 2" and "Failsafe") have already
been confirmed by the MULTImate with "ok".
If you do not wish to change individual values:
Confirm the appropriate parameter in turn with twice.
The display must confirm each parameter with
"--> OK!"
Setting: Do you really want to overwrite the previously
stored servo positions?
• If no:
• If yes:
Note: pressing sends the already modified data -
such as servo reverse, transit speed etc. - to the servo.
This is necessary for software reasons; the servo is
then re-started in order to set its position correctly.
or , confirm with
or , confirm with
or , confirm with
Seite 16/22