Multiplex MULTImate V 1.42 Manual De Instrucciones página 35

4-4 Error count
4-5 Low voltage
4.0 V
4-6 Sensor addr.
4-7 RX Type
RM9 DR V1.00
4-8 RX reset
L
4-9 Send data
L
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
4-4 Zurück
...zu RX M-Link
4-4 Volt. err.
0
4-4 Sign. Err.
0
4-4 Clear errcnt
L
4-6 Go back
...to RX M-Link
4-6 Addr.voltage
L 0
4-6 Adress LQI
L 1
Display of recorded low-voltage errors (*)
Display of recorded signal errors (*)
* The counter can only be read out if the errors were saved at
the receiver before it was switched off: this is accomplished by
briefly pressing the SET button on the receiver when errors are
indicated.
Des Weiteren muss der Sender ausgeschaltet sein!
Erasing the error counter completely:
erases the error counter
Selecting the voltage threshold for low-voltage
errors
•
Available range 3.0 Volt ... 6.9 Volt
•
Change value with and
Confirm the set value with
Addressing the screen lines for receiver battery
voltage and downlink channel quality (LQI)
•
Available range 0 ... 15
•
Change value with and
Confirm the set value with
Displaying the receiver type and its software
version
Resetting the receiver to the factory default
settings:
resets the receiver to the default settings.
sends the altered settings to the receiver.
or ,
or ,
Seite 12/22