Additional Symbols For Installation, Operation, And Maintenance - Smarter tools S-200i Manual De Instrucciones

Operating manual
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Never weld on a pressurized cylinder – explosion will result.
Use only correct shielding gas cylinders, regulators, hoses, and fittings
designed for the specific application; maintain them and associated parts in
good condition.
Turn face away from valve outlet when opening cylinder valve.
Keep protective cap in place over valve except when cylinder is in use or
connected for use.
Read and follow instructions on compressed gas cylinders, associated
equipment, and CGA publication P-1 listed in Safety Standards.
1.3 Additional Symbols for Installation, Operation, and
Maintenance
FIRE OR EXPLOSION hazard.
 Do not install or place unit on, over, or near combustible
 Do not install unit near flammables.
 Do not overload building wiring – be sure power supply system
FALLING UNIT can cause injury.
 Use lifting eye to lift unit only, NOT running gear, gas cylinders,
 Use equipment of adequate capacity to lift and support unit.
 If using lift forks to move unit, be sure forks are long enough to
OVERUSE can cause OVERHEATING
 Allow cooling period; follow rated duty cycle.
 Reduce current or duty cycle before starting to weld again.
 Do not block or filter airflow to unit.
surfaces.
is properly sized, rated, and protected to handle this unit.
or any other accessories.
extend beyond opposite side of unit.
1-7
Tabla de contenido

Solución de problemas

loading

Tabla de contenido