Unpacking & Assembly - Echo PWE-1800 Manual De Instrucciones

u & a
nPackinG
• After unpacking the ECHO POWER WASHER, lay out parts and accessories. Familiarize yourself with the
parts in the package by comparing them to those listed on the "PACKAGE CONTENTS" page.
• The ECHO POWER WASHER requires some minor assembly. You'll need a Phillips screwdriver to install the
high pressure hose hook and the nozzle tray.
NOTE: Some parts may or may not be already assembled.
• High pressure hose is stored on the hose reel. With the front of the power washer facing towards you, insert
the un-threaded end of the high pressure hose into the square hole on the inner reel and begin turning the
handle away from you. When finished winding, push the handle in to lock it in place.
NOTE: The hose reel is only for storing the high pressure hose. The hose must be completely removed from
the hose reel each time you use the power washer.
• Slide the spray gun holder onto the left side of the washer when facing it. This does not require any screws.
(Fig. 1)
• Slip tab into slot and screw the nozzle tray on the bottom portion of the unit. (Fig. 2) When placing the gun
with the lance attached the nozzle will rest in this tray.
• Easily remove the power cord from side of unit by swiveling the bottom cord hook to the right or left until
it faces up. The power cord then can be easily slid off of the side of the power washer unit. (Fig. 3)
• Swivel cord hook
back down when
ready to wrap the
cord back into place
for storage.
8
ECHO PWE-1800 Pressure washer manual 2015.indd 8
SSembLy
Fig. 1
Fig. 2
Fig. 3
2016-04-12 8:26 AM