Quick Start Guide - GBC MFPP-A1 Manual De Instrucciones

3. QUICK START GUIDE

Professional Puncher must be connected to AC power to enable
any feature of the machine. Below are three modes of operation of
Professional Puncher.
1. Bypass Mode:
This operation will allow paper to pass through the Professional
Puncher without being punched.
This is the default mode of operation for Professional Puncher.
Make sure the Punch Icon is not selected in the printer's User
Interface.
2. Punch Mode:
This operation will punch the trail edge of all sheets that pass
through the Professional Puncher.
Step 1: A properly configured die set must be inserted before
running punch mode. See section 4.A for details on Die set
changes and follow the labels on the die set for configuration.
Step 2: Before starting a print job select the Punch mode from
the printer's UI.
Professional Puncher will now function in Punch mode.
3. Crease Mode:
This operation will crease in the middle of all sheets that pass
through the Professional Puncher.
Step 1: A Crease die-set must be inserted to enable the Crease
mode. See section 4.A for details on Die set changes.
Step 2: For some controllers, before starting a print job select
the Crease mode from the printer's UI. See printer manual.
Professional Puncher will now function in Crease mode.
Note: Crease mode is out of specification for certain printer
configurations.
In some cases, creasing will not prevent cracking when the media
is folded.
DOWN
Layout of Professional Puncher LCD User Interface
4. Die Set Configuration:
To configure the Die Set for the desired sheet size that is being
processed see section 8 – Die Set User Manual.
5. Restrictions:
I. Creasing accuracy may decrease, in certain operating
environments, when stiff paper or coated paper with a
smooth surface is used. In this case, turn <REG.
Multi Function Professional Puncher – A1
UP
ENTER/
OK
ACCURACY> of the Multi Function Professional Puncher-
A1 to <ON>. However, turning this on causes reduced
productivity.
II. When punching or creasing 200gsm paper or above, with
grain direction in the long orientation, paper jams may
occur. The problem may not occur with the grain direction
in the short orientation.
EN
5