Preparing The Appliance - Fagor PRES-05 Manual De Instrucciones

a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
•
For greater protection, we recommend
installing a residual current device
(RCD) with an operational residual
current not exceeding 30 mA. Ask your
installer for advice.
•
Do not leave the appliance unattended
when it is turned on because it can be
dangerous.
• When removing the plug never pull on
the cable.
• Unplug the appliance before cleaning or
maintenance.
•
In the event of fault or malfunction
where the appliance is not to be used,
turn off the appliance and do not
attempt to repair. If a repair is required,
contact a Technical Assistance Service
authorised by the manufacturer and
request the use of original spare parts.
•
If the cable for this appliance is damaged,
contact an authorised Technical
Assistance Service for it to be replaced.
• Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
•
Do not use or let any part of the appliance
come into contact or near hot surfaces
(kitchen gas or electric hobs or ovens).
• Do not use detergents or abrasive
sponges to clean the appliance.
•
Do not touch the hot surfaces. Use the
handles.
•
Do not let the cable come into contact
with the hot parts of the appliance.
•
Use the appliance at a room
temperature of between 2°C (54°F)
and 26°C (80°F).
•
When installing the appliance, make
sure that there is a gap of at least 0cm
at the sides and at the back of the
appliance. This will allow for adequate
ventilation.
•
Do not move the appliance when the
barrel is inside.
•
Do not immerse the appliance or the
power cable in water or in any other
kind of liquid.
• Do not place anything on top of the
appliance.
•
Do not insert anything into the air vents.
• Do not put the beer barrel into the
freezer. This could affect the quality of
the beer and the barrel could explode.
SAFETY WARNINGS FOR THE CO
CYLINDER
• Pressurised cylinder: use with caution
and do not expose it to sunlight or
temperatures higher than 50ºC.
• Store the CO cylinders well away from
2
heat, in a cool, dry place.
• Keep well out of reach of children.
• The cylinders contain compressed gas.
Do not puncture or squeeze or alter the
cylinder in any way.
• The cylinder can only be used once. It
cannot be reused.
• Connect the regulator to the cylinder by
screwing it in firmly with your hand, and
only your hand.
• Do not apply oil or grease inside the
cylinder connection.
• DO NOT REFILL IT!
• To dispose of the cylinder, you must
follow the relevant waste disposal
procedure. For further information
on this subject, contact the local
authorities.
Instructions for use: Connect or screw the
control valve to the cylinder without over
tightening it. If the gas does not come
out, screw and unscrew the control valve
several times. After use, unscrew the
control valve from the cylinder: The seal is
automatic.
CAREFUL: Do not use a spanner or any
other tool to connect the cylinder to the
control valve. The connection must be
made only by using your hands.
4. PREPARING THE APPLIANCE
• Place the appliance on a dry, firm and
stable surface.
• Leave a gap of around 0cm at the
sides and at the back of the appliance.
This will allow for adequate ventilation.
• Place the drip tray (3) into the slots at
4
2