Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3
Inspection and description of the
machine
• On receiving the machine check its condition.To
unscrew the screws K using key 7, and to mount
the handles (see fig 7)
• Always keep it perfectly clean
• Check the supply cable and the extension lead
periodically
• Always keep alert when working
• Check that the parts are properly fixed (no
abnormal vibration) and that it is correctly
assembled.
SEE FIG. 1a-1b
Chassis-tank
1
Leg
2
Leg locking knob
3
Water pump
4
Head locking knob
5
90° to 45° locking knob
6
30 mm spanner
7
Drain plug
8
Motor
9
Lack of voltage switch
10
Operating handle
11
Disc casing
12
Removable guard
12b
Rail
13
Large table
14a
Small table
14b
Plate stops
15
Cutting head
16
Carriage
17
Manufacturer's plate
18
90° cutting guide
19
Plate side extension
20
Wheel for tightening the extension
21
Transport handles
22
Wheel for fixing the disc guard
23
Height adjustment plate
24
Height adjustment tightening knob
25
Cutting depth adjustment screw
26
Table tilting safety latch
27
24
4
Handling - Transport [
• Lock the moving head on the front part of the rail
using the knob (5).
• Hold the machine by the handles (22)
• Fitting the legs :
• Loosen the four flywheels (3).
• Bring two of the feet to the front (check the
angle of the feet connectors).
• Lift the front and lower the feet into the
suports.
• Proceed in the same way for the back.
• Immobilize the flywheels (3).
For these different operations
always disconnect the machine
5
Check before starting
Please read the instructions for use
prior to operating the machine for
the first time.
Motor off.
The
working
completely cleared, well lit and all
safety hazards removed (no water or
dangerous objects in the vicinity)
The
operator
protective clothing appropriate
to the work he is doing. We
recommend that this includes
both eye and ear protection
The use of ear protection is
mandatory.
Any persons not involved in the
work should leave the working area
Use only blades marked with a
maximum operating speed greater
than blade shaft speed
6
Fitting the disc [
Disconnect the machine by unplugging
the supply cable.
1a]
FIG.
area
must
be
must
wear
3]
FIG.
Tabla de contenido
