Troubleshooting; Reset To Factory Default - EVERSPRING SA801 Guía De Usuario

Troubleshooting

The troubleshooting table lists some possible causes and solutions. Please
contact your original retailer or nearest service center if the below solutions
cannot solve your problem.
Symptom Possible Cause
SA801 LED indicator not No battery is inserted or
displaying battery is flat
SA801 failure
The LEDs on the keypad Check if the keypad has
are operating properly, but completed binding with
the keypad cannot arm or Gateway .
disarm the system.
Distance out of
operating range

Reset to factory default

Resetting the keypad to factory default settings will remove all binding with
HomeSys and resets the administrator PIN code to factory default.
To reset to factory default:
1. Remove the batteries.
2. Set the Jumper link J1 to Off position as shown below:
3. Refit the batteries. The Keypad numbers 0-9 will flash three times.
4. Set the Jumper link J1 back to the ON position as shown above.
Specifications
Battery Type
Operating Frequency
Recommendation
** Specifications are subject to change and improvement without notice.
Check if 3 batteries are
inserted properly
Send the unit to the service
center and do not open it
Proceed with "Manual
Federal Communication Commission Interference Statement
binding"
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
Change the mounting
designed to provide reasonable protection against harmful interference in a
location of SA801 closer to
the gateway.
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
-
OFF position
-
-
ON position
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
5
AA 1.5V Alkaline battery x 3
868MHz (EU)/ 923MHz (America)
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
A501112398R01