EVERSPRING SA801 Guía De Usuario página 5

1. Undo and remove the fixing screw from the bottom edge of the Keypad and
remove the wall mounting plate (Figure 2).
2. Using the mounting plate as a template, mark the positions of the two fixing
holes on the wall.
3. Fix the mounting plate to the wall using the screws and wall plugs provided
(Figure 3). Do not over-tighten the fixing screws as this may distort or
damage the mounting plate.
4. With batteries installed inside, slide the keypad into its wall mounting plate
and screw the fixing screw to secure it in place. Do not over-tighten the
screw.
Enabling/Disabling the Panic function
If the keypad is mounted outside of your home, e.g. in apartment hallway or
stairs, you may choose to disable the Panic function to prevent abuse by
strangers triggering an alarm condition in your home.
To do this you need to enter the keypad's own administrator PIN code. This is
separate from the access code created under "Configuration" section.
Note: The default administrator PIN code is
you change this to another four digit number. See the next section on how to do
this.
a. Panic Disable:
Press administrator PIN code followed by "0", e.g.
b. Panic Enable:
Press administrator PIN code followed by "1", e.g.
Note: the default setting is enabled.
Changing the Administrator PIN code
To change the Administrator password, press the following keys in sequence:
1. Press current administrator code followed by "2", e.g.
2. Enter new administrator code followed by "2", e.g.
If you have forgotten the administrator PIN code, refer to section "Reset to
factory" to reset the PIN code.
Maintenance
If the battery level becomes low, the low battery LED will flash 4 times when any
key is pressed. Batteries should be replaced as soon as possible by following
the steps below:
Note: Removing the keypad from its wall mount will trigger the tamper
protection switch and cause an alarm. Prepare a keyfob controller SR804 ready
to quickly disarm the system or use the App.
1. Undo the fixing screw at bottom of keypad and remove it from the wall
mounting plate.
2. Replace with three AA alkaline batteries.
3. Refit and secure the Keypad onto the mounting plate.
4
1-2-3-4
. It is recommended that
1-2-3-4-0
1-2-3-4-1
1-2-3-4-2
8-8-8-8-2