Configuration - EVERSPRING SA801 Guía De Usuario

7. The following screen will appear. This means the gateway is entering binding
mode.
8. Insert the batteries with correct polarity at this point.
9. The screen below will appear in 10 seconds if the process is successful.
10. Time-out will occur if the binding process was unsuccessful. Please refer to
the Manual Binding procedure below.
Manual Binding
1. Repeat steps 5 to 8 of the Binding with HomeSys section.
2. Press buttons 1-2-3-4-3, the keypad should enter binding mode.
3. This screen below will appear in 10 seconds if the process is successful.

Configuration

Set Users and their access codes:
From your HomeSys account select "SETTINGS", then "System".
1.
2