Idiomas disponibles
Idiomas disponibles
Technical Data
at 90 PSI Operating Pressure
Power
Torque
Air consumption
f u l l l o a d
Air consumption
no load
No load speed
Sound pressure level
according ISO 15744
Vibration according
ISO 8662
Weight without hose
Recommended air quality
according DIN ISO 8573-1
Air hose ID
Spindle thread
LPB 12
Machine components:
1
Gear head
2
Water connector
3
Safety l e v e r t h r o t t l e
4
Adjustable Valve
5
Muffle r
6
Wrench 11 mm
Recommended Accessories
7
Coupling with min ID 4.5 mm/3/16"
8
1/2"- Service Unit ( Capacity 5-8
Micron).
Suitable Abrasives/Burs
9
Velcro backing pads up to 2" dia.
Additional Abrasives and Tools
can be found in the the SUHNER catalogs
LXB 10
250 Watt
0.7 N m
13,3 cfm
3
0,41 m
/min
15,4 cfm
3
0,48 m
/min
10000 rpm
79 dB(A)
2
< 2.5 m/s
0.39 kg
3/4/4
8 mm/5/16"
1 / 4 " - 2 0
Air supply requirements:
The DIN ISO quality specifications require, that
a i r i s f r e e o f s o l i d p a r t i c l e s l a r g e r t h a n 5
micron, remaining water content to be max. 6
3
g/m
(pressure dew point+3 degree C) and
air may contain 5 mg/m
please observe the following:
• Operating with dirty and unlubricated air
reduces tool life substantially.
Before installing extension hoses, blow them
clean and minimize , if at all necessary
coupling and keep them clean.
• Conserve:
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions:
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
Protect mounted points from knocks and
grease.
• Secure work, use clamps or a vise to hold
work.
• The grinder operator shall wear safety
goggles or face shield and gloves and
earplugs at all times when the grinder is in
operation.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear plug and/or ear
mufflers.
For additional safety instructions
refer to enclosed brochure DL 39 220 01
Operation conditions and instructions
Safety lever throttle action
A) Lever action:1 Tilt safety pin towards arrow
direction and 2 press down lever.
B) Ring throttle action:
Turn ring throttle counter clock wise to open,
turn clock wise to close. Observe arrow
d i r e c t i o n .
Attention: Before connecting to air supply,
check that throttle is closed.
Grinding/Cleaning
Do not treat any material containing asbestos.
Change of tools/abrasives
• Disconnect air supply before changing tools/
abrasives
G B
3
o f o i l . T h e r e f o r e
