Operation - Prince Castle TX-230ECE Manual Del Operador

1
Press the On/Off Button to turn the unit on.
R R D D Y Y
2
Turn the Bun Thickness Adjustment Knobs to the desired setting.
Left Side Control
1 = Thinnest Cut
6 = Thickest Cut
NOTE: Factory preset temperature is 570°F and should provide satisfactory results in most applications. Maximum
temperature of unit is 580°F (304°C).
TX-230ECE 537-530

Operation

The conveyor will begin to turn
and the display will read " L L O O ".
When the unit is at operating
temperature the display will
read " R R D D Y Y " and the ACT (actual
temperature) LED will be lit.
Temperature LED's
Display
Power On/Off Button
Right Side Control
A = Thinnest Cut
F = Thickest Cut
3
Feed the buns into the bun chute, flat (toasted) side up.
Press the On/Off Button to turn the unit off.
4
3
TOASTER
TX-230ECE
Bun Chute
If the heater is above 450°F, the
display will alternately show
" C C O O O O L L " and " O O F F F F ", and the con-
veyor belt will continue to run
approximately 45 minutes. When
the unit has cooled sufficiently,
the display will go blank and the
conveyor motor will turn off.
Power On/Off Button
Printed in USA 0320 © 2003