Rear Panel Features - Alto Professional ZMX52 Manual De Inicio Rápido

REAR PANEL FEATURES

1. POWER IN – Use the included power adapter to
connect the mixer to a power outlet. While the power
is switched off, plug the power supply into the mixer
first, then plug the power supply into a power outlet.
2. POWER SWITCH – Turns the mixer on and off. Turn
on the mixer after all input devices have been
connected and before you turn on amplifiers. Turn off
amplifiers before you turn off the mixer.
3. MIC INPUT – Connect a microphone to these inputs
with an XLR cable.
4. LINE INPUT * – Connect line-level devices to these
inputs with 1/4" cables.
5. GAIN – Adjusts the channel audio level (pre-fader
and pre-EQ gain). Adjust this so that the PEAK LED
just barely lights up during the loudest parts of the
song.
6. HI EQ (TREBLE) – Adjusts the high (treble)
frequencies of the channel.
7. LO EQ (BASS) – Adjusts the low (bass) frequencies
of the channel.
8. CHANNEL PAN – Adjusts the (mono) channel's
position in the stereo field.
9. BALANCE (CH 2/3 & 4/5) – Adjusts the balance
between Channels 2 and 3 and Channels 4 and 5.
10. PEAK LED – The LED will flash if the signal is
clipping. If this happens, decrease the setting of the
GAIN knob or CHANNEL VOLUME knob.
11. CHANNEL VOLUME – Adjusts the audio level on the
channel.
12. AUX INPUTS – You may connect these inputs to the
outputs of an external sound source using a standard
stereo RCA cable (sold separately). You can send
this channel to the monitor mix (using the AUX TO
PHONES switch) and/or the main mix (using the AUX
TO MIX switch).
13. AUX OUTPUTS – You may connect these outputs to
the inputs of an external recording device using a
standard stereo RCA cable (sold separately).
14. MAIN MIX OUTPUTS – Use standard 1/4" cables to
connect these outputs to the house speaker or
amplifier system.
controlled by the MAIN LEVEL knob.
15. PHONES OUTPUT – Connect your 1/4" stereo headphones to this output.
controls the volume.
16. AUX MIX – Press this button to select which signal is routed to the MAIN MIX OUTPUTS – the main
mix or the signal from the AUX INPUTS.
17.
AUX TO PHONES – Press this button to select which signal is routed to your headphones – the main
mix or the signal from the AUX INPUTS.
18. PHONES – Adjusts the volume of the PHONES output.
19. MAIN LEVEL – Adjusts the volume of the MAIN MIX OUTPUTS.
20. LED METERS – Shows the audio level of the main mix. Turn the volume down if the CLIP LED lights
up excessively.
21. POWER LED – Illuminates when the mixer is on.
The level of these outputs is
2
3
4
5
6
8
8
10
11
* When using LINE INPUTS 2/3 and 4/5:
• If only the left channel is used, the signal
will be heard in both left and right
channels and the balance will not be
adjustable.
• If only the right channel is used, the signal
will be heard in the right channel only.
4
1
14
4
14
12
9
17 16
18
12
10
11
20
9
10
11
19
The PHONES knob
15
13
13
21