How The Air Conditioner Works; Dehumidifying Operation; Maintenance - Qlima S5025 Instrucciones De Uso

H

HOW THE AIR CONDITIONER WORKS

Press Sleep button
AUTOMATIC OPERATION
1
Set
• When you set the air conditioner in AUTO mode (button 2 on the remote
Tempe-
1
rature
controller), it will automatically select COOLING, HEATING or FAN only
1 hour 1 hour
COOLING
operation depending on what temperature you have selected and the room
Press Sleep button
temperature.
Set
1
• The air conditioner will control room temperature automatically round the
Tempe-
rature
1
temperature point set by you.
1 hour 1 hour • If the AUTO mode is uncomfortable, you can select desired conditions man-
HEATING
ually.
Cooling Fan only Cooling Fan only Cooling
SLEEP/ECONOMIC OPERATION
Room
tempe-
• When you push SLEEP button f during COOLING, HEATING or AUTO oper-
rature
Time
Set temperature
ation, the air conditioner will automatically increase (cooling) or decrease
(heating) 1ºC per hour. The set temperature will be steady 2 hours later and
DEHUMIDIFYING
remains steady for 5 hours. After 5 hours the unit will stop. The fan speed
will be automatically controlled.

DEHUMIDIFYING OPERATION

• The dehumidifying mode will automatically select the dehumidifying operation based on the difference
between the set temperature and the actual room temperature.
• The temperature is regulated while dehumidifying by repeatingly turning on and off of the cooling
operation or fan only. The fan speed is controlled automatically.
• In normal cooling operation the air conditioner will also dehumidify the air.
G
NOTE
When the air conditioner is dehumidifying it is likely that the room temperature will decrease.
It is therefore normal that a hygrostat will measure a higher relative humidity. The absolute
humidity in the room will however be lowered, depending on the amount of moisture produced
in the room (cooking, people etc).
4
60 60
I

MAINTENANCE

G
WARNING
• It is necessary to stop the air conditioner and disconnect the power
House-
hold
Drain
supply before cleaning.
Cleaner No
• If a 4.8kW model is used, interrupt the power supply.
Cleaning the indoor unit and remote controller
G
CAUTION
Thinner
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor unit if
it is very dirty.
• The front panel of the indoor unit can be removed and cleaned with
Filter handle
water. Then wipe it with a dry cloth.
• Do not use a chemically treated cloth or duster to clean the unit.
• Do not use benzine, thinner, polishing powder, or similar solvents for
cleaning. These may cause the plastic surface to crack or deform.
Cleaning the filter
A clogged air filter reduces the cooling efficiency of this unit. Clean the filter once every 2
weeks.
1. The air filter is under the top air inlet grill.
2. Grip the tab on the end of the filter, lift it up, then pull it towards yourself.
3. Remove the screen filter from the indoor unit.
• Clean the screen filter once every two weeks.
• Clean screen filter with a vacuum cleaner or water.
4. The black active carbon filter cannot be cleaned. This filter will simply not filter
unpleasant odours anymore once dirty. At that moment this filter needs to be
replaced by a new filter. (available at your dealer). It is advised to exchange this filter
twice every season.
5. The green coloured 3M HAF filter will show clear signs of dirt on and in the filter
once dirty. When dirty this filter cannot be cleaned and needs to be replaced by a
new filter (available at your dealer). It is advised to exchange this filter twice every
season.
New filter
6. After replacing the active carbon filter and the 3M HAF filter in the filter holder on
the screen filter, the screen filter can be replaced into the air conditioner.
7. Ensure before replacing that the filter is completely dry and has no defects.
8. Install the air freshening filter back into position.
9. Insert the upper portion of air filter back into the unit taking care that the left and
right edges line up correctly and place filter into position.
Maintenance
If you plan to idle the unit for a long time, perform the following:
1. Operate the fan for about 6 hours to dry the inside of the unit.
2. Stop the air conditioner and disconnect power. If a 4.8kW model is used, interrupt
the power supply. Remove the batteries from the remote controller.
Recommended change of filter
4
61 61