Makita 6807 Manual De Instrucciones página 5

Switch action
1
2
003560
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
Even with the switch on and motor running, the bit
•
will not rotate until you fit the point of the bit in the
screw head and apply forward pressure to engage
the clutch.
Reversing switch action
A
003561
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
1. Switch trigger
2. Lock button
1. Reversing
switch lever
B
1
Speed change knob
1 2
003562
Two rpm ranges can be preselected with the speed
change knob.
For low speed range (0 - 1,000 rpm), turn the knob so
that the pointer points to the number 1 marked on the
knob. (Fig.A)
For high speed range (0 - 2,200 rpm), turn the knob so
that the pointer points to the number 2. (Fig.B)
If it is hard to turn the knob, pull the switch trigger half-
way for running the tool at low speed and turn the knob
again.
CAUTION:
Do not turn the knob while the tool is running at full
•
speed. Malfunction of the tool may result.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
013573
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool, whichever is
convenient.
5
1. Speed change
knob
1 2
2. Pointer