Screwdriver Safety Warnings; Functional Description - Makita 6807 Manual De Instrucciones

SCREWDRIVER SAFETY
WARNINGS
1. Hold power
surfaces, when performing an operation
where the fastener may contact hidden wiring
or its own cord. Fasteners contacting a "live"
wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool
in high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
tool by insulated
GEB017-4

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
gripping
•
unplugged before adjusting or checking function
on the tool.
Depth adjustment
1
003557
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve
equals 1.5 mm (1/16") change in depth.
Adjust the locking sleeve so that the distance between
the tip of the locator and the screw head is
approximately 1 mm (3/64") as shown in the figure.
Drive a trial screw into your material or a piece of
duplicate material. If the depth is still not suitable for the
screw, continue adjusting until you obtain the proper
depth setting.
USD201-2
A
003558
003559
4
A
B
1
2
1
2
1. Locking sleeve
1. Approx. 1mm
(3/64")
2. Locator
1. Approx. 1mm
(3/64")
2. Locator