Resetting The Memory Program Cycle Counter; Setting The Sound - Buffalo GK642-E Manual De Instrucciones

Reading each Memory Program's Cycle Counter
1. Clear all operations by pressing the Stop/Cancel button.
Press the Check button to enter Check mode.
2. Press the Start button, and then press any Number button,
from 1 to 20, and the number of cycles for that particular
Memory Program will be displayed. The cycle count is
displayed in units of 10.
For example, if Memory Program 5 has been used
100 times, the display will show '10'.
3. After one second, the display will clear automatically. If
you want to check other Memory Programs, just enter the
Memory Program numbers.
4. Press the Stop/Cancel button to exit the Checking mode.
As the display uses units of 10, the cycle counts are approximate. The cycle count
displayed increases every ten cycles.
For example, if the cycle count were 90-99, "9" would be displayed, The "9" would
change to "10" on the 100th cycle. The cycle counter function has a limit of 99,990
cycles. Once that number is exceeded, the cycle counter will automatically clear and
start again from "0".
GK642-E_XEU-DE68-04280B-01_EN.indd 17
RESETTING THE MEMORY PROGRAM CYCLE
COUNTER
1. Clear all operations by pressing the Stop/Cancel button.
The display will show ':0".
2. Hold the Number '0' and then press Defrost button.
The microwave will emit a Beep sound confirming the reset
operation.
Clearing all numbers on the display using the Stop/Cancel
button will show "0" as below.
3. Press the Stop/Cancel button to exit the Resetting mode.

SETTING THE SOUND

1. Press the Sound button to adjust sound volume. The basic
sound volume is "LO" and when you press the Sound
button repeatedly, the sound volume changes in the
following order - MED, HI, OFF, LO one by one.
2. Press the Start button to exit Sound mode. The display will
show ":0".
Indicator
English - 17
Sound
HI Loud
MED Middle
LO Low
Blank Off
2014-06-27 6:53:06