Ariens Max Zoom Manual Del Operador página 17

WARNING: AVOID INJURY
Read a nd understand entire
Safety section before proceeding.
Proper maintenance can prolong the life of
unit. The following charts show the
recommended service schedule. More
frequent service may be required due to
working conditions (heavy loads, high
ambient temperatures, dusty conditions, or
airborne debris).
See the maintenance instructions in the
Engine Manual for additional information.
Period Task
Each
Use
Service
Check Safety Interlock
WARNING: Safety interlock system
failure and improper operation of unit can
result in death or serious injury. Test this
system each time the unit is operated. If
this system does not function as
described, do not operate until repairs are
made. See Safety Interlock System on
page 12.
Check Parking Brake See Parking Brake Interlock System on page 12.
Interlock System
Check Hydraulic Fluid Check hydraulic oil level mark on cap/dipstick. Add
20W50 engine oil as needed. Do not overfill. See
Check Hydraulic Fluid Level on page 19.
Check Tires
Clean Unit
See Specifications on page 31for correct tire
pressure.
,_ CAUTION: Avoid injury! Explosive
separation of tire and rim parts is possible
when they are serviced incorrectly:
Do not attempt to mount a tire without the
proper equipment and experience to
perform the job.
Do not inflate the tires above the
recommended pressure.
Do not weld or heat a wheel and tire
assembly. Heat can cause an increase in air
pressure resulting in an explosion. Welding
can structurally weaken or deform the
wheel.
Do not stand in front or over the tire
assembly when inflating. Use a clip-on
chuck and extension hose long enough to
allow you to stand to one side.
Clean engine, battery, seat, mower deck, etc. of dirt
and debris. Do not use solvents, hard cleaners, or
abrasives.
IMPORTANT: Do not spray the unit with water,
especially when the unit is warm from operation.
Water can seep into bearings and damage them.
NOTE: Protect painted surfaces with automotive
type wax.
GB - 17