Safety Information - Rothenberger ROPULS 1000000145 Instrucciones De Uso

b) Do not use the power tool if the switch does not turn it on and off. Any
power tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons un-
familiar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, break-
age of parts and any other condition that may affect the power tools operation. If
damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Use the power tool, accessories and tool bits etc., in accordance with these
instructions and in the manner intended for the particular type of
power tool, taking into account the working conditions and the work
to be performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.

1.3 Safety information

Our equipment must be installed by approved specialists in the sanitary and heating trade.
Check for possible transport damage prior to installation.
Protect equipment against frost and do not set it up close to a heater with high radiating tempera-
ture. The product is approved for a water temperature of 30 ºC max. / ambient temperature 40 ºC
max.
You absolutely must follow the flow direction marked by arrows on the appliance.
When dealing with food and tap water, special attention must be paid to hygiene.
The obligation to due diligence lies with the operator of the tap water system or the person he has
authorized.
Installation must comply with the regulations of the German Association for Gas and Water Engi-
neering (DVGW, DIN 1988), SVGW in Switzerland, ÖVGW in Austria and local provisions.
The supplied water with dirt particles must first be filtered out through a micro-filter (DIN 1988,
DIN 50930).
Installation must be in accordance with the respective drawing.
Before connecting the tap water system, make sure that the rinse compressor and all accessory
components (such as hoses, pressure regulators, etc.) are completely sanitary.
If the water pipe system is used for earthing, the appliances must be electrically bypassed (VDE
190 sect. 3 H, SEV in Switzerland and ÖVE in Austria).
In case of power cuts or defect of the transformer fuse, the water will run into the sew
age system during regeneration. In this case immediately close water supply to softener
and contact customer service!
For enquiries, please quote appliance type, number, year, serial no. etc.
What not to do
Do not touch the head, the cylinders, the cooling fins or the feed line, because during
operation they reach very high temperatures and remain hot even for some time after the
device has been stopped.
Never place flammable materials on or near the compressor.
Never direct the compressed air stream toward people or animals.
Do not run the compressor without an air filter.
Do not use the device in a potentially explosive environment.
The air flow to cool the compressor unit must not be impeded
Therefore, position at least 50 cm away to obstacles.
ENGLISH 15