Rotating The Machine Head; Starting Operation - profiline BTI-WKS 115 V Instrucciones De Servicio

max.
[mm]
D
d
115
D
125
b
D
115
125
d
75
b
D

Rotating the Machine Head

Before any work on the machine itself, pull
the mains plug.
Completely unscrew the four screws. Rotate the
machine head carefully, without removing it from
the housing, to the new position. Screw in and tighten
the four screws again.
Operation

Starting Operation

Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be
operated with 220 V.
46 | English
[mm]
b d [rpm]
6 22.2 11000
6 22.2 11000
11000
– –
11000
30 M 14 11000
The machine head can
be rotated with respect
to the machine housing
in 90° steps. In this man-
ner, the On/Off switch
can be brought into a
more convenient position
for special working situa-
tions, e.g., for cutting
operations using the cut-
ting guide with dust
extraction protection
guard 20/cut off stand or
for left-handed persons.
When operating the machine with power from mobile
generators that do not have sufficient reserve capacity
or are not equipped with suitable voltage control with
starting current amplification, loss of performance or
[m/s]
untypical behavior can occur upon switching on.
Please observe the suitability of the power generator
80
being used.
80
Switching On and Off
To start the power tool, push the On/Off switch 4 for-
80
wards.
80
To lock the On/Off switch 4, press the On/Off switch
4 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 4 or, if it is locked, briefly push down the back of
45
the On/Off switch 4 and then release it.
Check grinding tools before using. The grind-
ing tool must be mounted properly and be
able to move freely. Carry out a test run for at
least one minute with no load. Do not use
damaged, out-of-centre or vibrating grinding
tools. Damaged grinding tools can burst and cause
injuries.
Kickback stop (BTI-WKS 125 VRE)
In case of a sudden drop in speed, e. g. jamming while
carrying out a separating cut, the power supply to the
motor is interrupted.
To restart the operation, switch the On/Off switch 4
to the Off position and start the machine again.
Restarting protection (BTI-WKS 125 VRE)
The restarting protection feature prevents uncontrolled
restarting of the machine after an interruption in the
power supply.
To restart the operation, switch the On/Off switch 4
to the Off position and start the machine again.
Reduced starting current (BTI-WKS 125 VRE)
The electronic reduced starting current limits the power
consumption when switching the tool on and enables
operation from a 13 ampere fuse.
Constant Electronic Control (BTI-WKS 125 VRE)
Constant electronic control holds the speed constant
at no-load and under load, and ensures uniform work-
ing performance.
1 609 929 L12 • 19.3.07