Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATIONINSTRUCTIONS
CONNECTING ELECTRIC DRYERS
(cont.)
AWARNING'.
• Connect
the power
cord to the terminal
block.
Each colored
wire should be connected
to same color screw.
Wire color indicated
on manual
is connected
to the same color
screw
in block.
Failure to follow these
instructions
may result in a short or overload.
• Grounding
through
the neutral
conductor
is prohibited
for: (1) new branch-circuit
installations,
(2) mobile
homes,
(3) recreational
vehicles,
and (4) areas where
local
codes
prohibit
grounding
through
the neutral
conductor.
_
Three-wire Connection for Electric Dryers: Power Cord
° A 3-wire connection
is NOT permitted on new
° Use a \ conductor
construction
after January 1, 1996.
and closed loop or forked terminals with
° A UL-listed strain relief is required,
upturned ends.
Terminal
Block
U L- Listed
Strain Relief
Remove the terminal block access cover
on the upper back of the dryer. Install a
UL-listed strain relief into the power cord
through-hole;
then thread a UL-listed, 30A,
240V, 3-wire, #10 AWG-minimum
copper
conductor
power cord through the strain
relief.
......... _
iiii_
_ii_ ¸ Hot
_Neu_
(Black)
(White)
(Red)
Attach the two hot leads of the power cord
to the outer terminal block screws. Attach
the neutral wire to the center terminal block
screw. Connect the external ground (if
required by local codes) to the green ground
screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
Capítulos
Tabla de contenido
Solución de problemas
