Automatic Ttl Fill-In Flash Mode; Automatic Flash Mode - Metz MECABLITZ 58 AF-1 Manual De Instrucciones

tion (see camera operating instructions for further details). In the case of ADI
metering, additional distance data from the lens is incorporated into the flash
exposure process. The selection and/or setting of the preflash TTL and ADI mete-
ring operating modes are carried out on the camera (see camera operating
instructions).
The flash unit must be set to the TTL flash operating mode.
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
TTL
• Set the flash mode using the UP
you choose is then highlighted. The setting takes effect immediately.
• Press the „Return" button to change the display back to the normal view.
If the „Return" button is not pressed, the display will change back to the
normal view after about 5 seconds.
If the shot was properly lit, the correct exposure indication
about 3 seconds (see 13).
TTL flash mode
This analogue flash mode is supported by older analogue cameras. It is the nor-
mal TTL flash mode (TTL flash mode without preflash).
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
TTL
• Set the flash mode using the UP
you choose is then highlighted. The setting takes effect immediately.
• Press the „Return" button to change the display back to the normal view.
If the „Return" button is not pressed, the display will change back to the
normal view after about 5 seconds.
and DOWN keys. The flash mode
will flash „OK" for
and DOWN keys. The flash mode
TTL
5.3 Automatic fill-in flash mode
With most camera models, the auto programme mode P and subject programme
activate the automatic fill-in flash mode in daylight (see the camera's operating
manual).
With the fill-in flash you can remove annoying shadows and achieve a balanced
exposure between motive and background in shots with backlight. A computer-
controlled metering system takes care of the appropriate combination of shutter
speed, working aperture and flash output.
Ensure that the frontlighting source does not shine directly into the lens, as this
will interfere with the camera's TTL metering system.
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera's TTL metering system.
An adjustment or display for the automatic TTL fill-in flash mode on the flash unit
doesn't occur in this case.

5.4 Automatic flash mode

In the automatic flash mode A, the flash unit sensor
reflects back from the subject. The sensor
only measures the light for the time a flash is fired by the mecablitz. The flash is
cut off as soon as sufficient light has been emitted for correct exposure. The sen-
sor of the mecablitz has to be directed at the subject.
The maximum range is shown on the LC display. The shortest shot distance is
approximately 10% of the maximum distance range. The subject should be loca-
ted within the middle third of the distance range shown on the LC display to
allow the electronic system sufficient leeway for compensation.
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
A
• Set the flash mode using the UP
selected is then highlighted. The setting takes effect immediately.
measures the light that
has a coverage of about 25°, and
and DOWN keys. The flash mode
87