Torque Limiter - Worx WX333 Manual Original

ADDITIONAL SAFETY
POINTS FOR YOUR
ROTARY HAMMER
1. wear ear protectors. Exposure to noise
can cause hearing loss.
2. use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
3. Always wear a dust mask.
4. hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden wiring
or its own cord. Cutting accessory
contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
5. Connect the mains plug only when the tool
is switched off. After using, pull the mains
plug.
6. Always direct the cable to the rear away
from the machine.
7 . Persons under 16 years of age are not
8
permitted to operate this machine.
8. Keep the tool and accessories out of the
reach of children.
9. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
10. Fully unwind cable drum extensions to
avoid potential over heating.
11. When an extension cable is required you
must ensure it has the correct ampere
rating for your power tool and that it is in
a safe electrical condition.
12. Ensure your mains supply voltage is the
same as your tool rating plate voltage.
13. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
14. Always check walls and ceilings to avoid
hidden power cables and pipes.
15. After long working periods, external metal
parts and accessories could be hot.
16. Wear eye protection when operating this
tool.
17. Your hand must hold on the handle when
you are working. Always use the auxiliary
Rotary hammer
handles supplied with the tool. Loss of
control can cause personal injury.

TORQUE LIMITER

There is a clutch in your rotary hammer.
The torque limiter will actuate when a certain
torque level is reached. The motor will
disengage from the output shaft. When this
happens, the bit will stop turning.
As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.
EN