Default Settings; Operating Instructions; Setting The Clock, Temperature Unit & Temperature - Waring Commercial WWB10G Manual Del Usario

2. For U.S., 120V hot water dispensers are provided with a
120V/15A grounding plug. For Canada, 120V/20A grounding plug.
Units must have a separate 120V/15A outlet.
TESTING THE CONNECTION/BEFORE FIRST USE
1. We recommend running at least one cycle before first use.
2. Open water supply line valve to hot water dispenser.
3. Turn on or plug in the power supply to the hot water dispenser.
The unit fills at the approximate rate of 1 gallon (3.8 L) per minute
depending on water line pressure.
4. Heat and discard at least one tank of water.

DEFAULT SETTINGS

• Temperature: 150°F/ 65°C
• Unit of measurement for temperature: Fahrenheit
• Water connection: Auto Fill/plumbed into water supply
• Night mode temperature: fixed at 158°F (70°C)

OPERATING INSTRUCTIONS

SETTING THE TEMPERATURE
1. Press
2. Use the
3. Once desired temperature is displayed, press the
to set or wait 10 seconds to set new temperature.
4. Display will show set temperature and PRESS START blinking.
5. Press
CAUTION: Water is very hot. Use caution when pouring or
transporting hot water. Accidental spills may result in severe burns.
SETTING °F/°C
1. Press
2. Once in program mode, PRESS and HOLD the
for 2 seconds.
3. Use the
4. Once desired unit of measure is selected, press
to set.
5. If neither button is pressed for 15 seconds, then the F or C
displayed will be programmed.
button once.
arrows to reach your desired temperature.
to begin filling and heating water.
button once.
arrows to switch from F to C.
9
button
button
twice