Introduction; Grounding Instructions - Waring Commercial WWB10G Manual Del Usario

INTRODUCTION

Thank you for purchasing this Waring
Dispenser.
Features & Benefits
• Hot water dispenser can be plumbed into a water connection or
it can be manually filled for multiple location and off-site use.
• Night Mode feature conserves energy and ensures hot water is
ready when you need.
• Fill rate: approximately 1 gallon per minute when unit is
plumbed-in
• Initial heat-up time to full capacity: approximately 3 hours
(assuming water is at 75°F (23°C) to start)
• Hot water dispenser will maintain set water temperature
within +/- 5°F
• Safety Features
• Tomlinson® No-Drip
• Excess water drain: Easily and safely removes excess water
from below spigot level.
• Knuckle guard: Protects hand from hot surface.
• Low water level sensor: In case water level gets low, an alarm
will sound and the heater will automatically be shut off. This
protects your machine. Once the issue is corrected/more water
added, the alarm will stop.
• High-level water sensor: If water level gets too high, an alarm
will sound and the heater will automatically be shut off.

GROUNDING INSTRUCTIONS

For your protection, the Waring
is equipped with a 3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be used
with a 3-prong plug. Referring to Figure 3, the adapter must be
grounded by attaching its grounding lug under the screw of the
outlet cover plate.
* Tomlinson , No-Drip and the Faucet and Handle configurations are registered trademarks of The Meyer Company, Cleveland, Ohio.
® ®
Commercial Hot Water
TM
tap operation*
®
Commercial Hot Water Dispenser
TM
4