How To Connect The Water Supply - Amana Manual Del Proprietário

Refrigerador duplex
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installing
Your Refrigerator
How
to Install
the
Handles
,.,.:.../
Stainless
Steel
Models
Loosen
lower
door clip on
refrigerator
door
with
1//4"
hex
nut
driver:
Inset't
1//u" hex
nut
driver
into predrilled
hole
at base
of handle
and
tighten
screw.
Locate
predrilled
hole
at
base
of handle,
and
t?t
hollow
end
of handle
over lower
door
clip.
Insert
sct'ew
plug
into
predrilled
hole,
as
illustrated.
Fit
other
end
of handle
over
upper
door
clip
and
slide
up as fat" as possible.
NO rE: If top of handle does not fit over top
clip, loosen lower clip further until fit can be
accomplished.
I
I 6Repeat
steps
2 through
5 to
install
freezer
handle.
To remove
after
initial
install...
Follow steps 2 through 5 in reverse order.
IMPORTANT: To avoid damage to unit, Use
a flat blade screwdriver
edge wrapped in
masking tape to remove screw piugs.
How
to
Connect
the
Water
Supply
]
WARNING
I
To avoid electrical shock which can cause severe personal injury or death, disconnect
power to refrigerator before
connecting water supply. After connecting water supply, connect power.
I
CAUTION
I
To avoid property damage, observe the following:
• Consult a plumber to connect copper tubing to household plumbing to assure compliance
with local codes and
ordinances.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed, water
pressure to water valve must be a minimum of 35 pounds per square inch.
• DO NOT use a self-piercing, or 3/16"(4.8 mm) saddle valve. Both reduce water flow, become clogged with time, and may
cause leaks if repair is attempted.
• Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches.
Do not overtighten.
• Wait 24 hours before placing unit into final position to check and correct any water leaks.
Matedads Needed
i ,,
• Brass nut and sleeve (see literature pack)
• /4 (6 mm) outer diameter flexible copper tubing
tumgb" engtnneedecltoreacnwater
• Shut-off valve (requires a 1/4"or 6 mm hole to be drilled
Add
to
NOTE:
8'(2
m)
into water supply before valve attachment)
supply for creation of service loop.
• Adjustable
wrench
I Rem°veplastic cap (A) #'°ml1{
€ llk/
Place brass nutand sleeve on copper tube
_
J
end and insert tube into valve inlet port.
Attach nut on copper tubing to valve inlet port.
6

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Amana distinctions

Tabla de contenido