How To Remove And Replace Light Bulbs - Amana Manual Del Proprietário

Refrigerador duplex
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Hints
and Care
How
to
Remove
and
Replace
Light
Bulbs
[
WARNING
]
To avoid electrical shock which can cause severe personal injury or death,
disconnect
power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
[
CAUTION
]
To avoid personal injury or property damage, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
r
Upper fresh
food section
1. Locate finger gaps on each side of clear light
shield. Insert fingers and press in on each side
of shield. Pull shield down and remove.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater
than
40 watts.
4. Replace light bulb cover by inserting front tabs of
light shield into holes in liner directly in front of light assembly.
g
Lower fresh food section and
Non-dispensing
model freezer section
1. Pinch bottom tabs (A) on light cover and pull straight
out.
2. Remove light bulb.
3. Replace bulb with appliance bulb no greater than 40
watts.
4.
B
Insert top tabs (B) of light cover into refrigerator liner and
A
snap bottom portion over light assembly.
Dispensing
model freezer section
1. Remove ice bin by lifting front of bin and pulling out.
2. Remove light bulb cover by pinching top tab (A) and
pulling cover out of liner.
3. Remove light bulb. Replace with appliance
bulb
no greater
than 40 watts.
4. Insert bottom tab (B) of light cover into liner and snap
top portion over light assembly.
5. Replace ice bin by sliding in until bin locks into place.
A
B
I Ice 'N Water dispenser
1. Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2. Replace light bulb with a 6-watt, 120 volt bulb.
17
How
to Get
the
Most
Out
of
Your
Energy
Dollar
When placing
refrigerator
into final
position,
allow fur 1" clearance
around the top and sides of unit to
supply
alnple
ventilation
fur
optimum
energy efficiency.
Avoid overcrowding
refiigerator
shelves.
This ]'educes effectivity
of
air circulation
around
fuod and
causes refiigerator
to run longer.
Avoid adding too much warm t_)od
to unit at one time. This overloads
colnpartments
and slows rate of
cooling.
• Do not use aluminum
t_)il, wax
paper, or paper toweling
as shelf
liners. This decreases
air flow and
causes unit to run less efficiently.
• A fieezer
that is 2/_full runs most
efficiently.
Locate ret¥igerator
in coolest part of
room. Avoid areas of direct sunlight,
or near heating
ducts, registers,
or
other heat producing
appliances.
If
this is not possible,
isolate exterior
by using a section of cabinet or an
added layer of insulation.
• Refer to owner's
manual
section on
temperature
controls
for
recommended
control
settings
Clean door gaskets
eve]y three
months
acco]ding
to Owner's
Manual
cleaning
instructions.
This
will assure that door seals properly
and unit runs efficiently.
• Take time to organize items in
refiigerator to ]educe time that door
is open.
• Be sure you] doors are closing
securely by leveling unit as
instructed in you] Owner's Manual.
Clean condenser coils of as
indicated in the owner's manual
every 3 months. This will increase
energy efficiency and cooling
performance.

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Amana distinctions

Tabla de contenido