Kawasaki KEL27B Manual Del Usuario página 16

WARNING
Confirm that the cutting blade is not
contacting the ground or other object
before starting the engine.
WARNING
During engine starting, cutting blade
will rotate and can cause injury.
The cutting blade is engaged when
engine speed is above idle.
This occurs normally during starting.
Keep bystanders, children and animals
at least 15 m (50 feet) away while start-
ing and operating your handheld edger.
Pull the recoil starter grip slowly to
●
engage the starter, then give a short,
quick pull.
WARNING
Recoil starter rope can cause injury if
released suddenly.
When starting the engine, grasp the
recoil starter firmly by the grip. Do not
grasp the starter rope itself. Always
control the rope during rewind into the
housing. Releasing the starter rope sud-
denly may allow the rope to whip
around and injure you or damage the
recoil starting mechanism.
A
A. Recoil Starter Grip
Slightly move the throttle lever to
●
switch the enrichment lever to the
"Running" (Engine idling speed) posi-
tion, and then move the throttle lever
back to fully closed (Engine idling
speed) position. If the engine fires, but
does not run continuously, repeat the
starting procedure.
NOTE
Should the engine fail to start, do not
⃝
try to pull the recoil starter grip too
many times with the enrichment lever
to the "Starting" position. This will
cause the fuel to flood into the cylinder
and make starting even more difficult.
In this case, set the enrichment lever to
the "Running" position and repeat the
starting procedure.
After starting, vary the engine speed a
⃝
few times, by operating the throttle
lever to draw out the remaining air in
the carburetor.
A
A. Enrichment Lever
15 15