Re-Assigning Device Keys - Universal Electronics ATLAS OCAP 5 Guia Del Usuario

4. Press and hold SETUP until the CBL key blinks
twice.

RE-ASSIGNING DEVICE KEYS

The Atlas OCAP 5-Device Remote Control can be set up
to control a second device of an already-assigned type.
For example, to have the unit control a TV, a Cable
Converter, and two audio devices (for example, two
audio receivers), re-assign the unused VCR key to
operate the second audio device as follows:
NOTE: VCR is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
1. On the remote control, press VCR once; it will
blink once. Then press and hold SETUP until
the VCR key blinks twice.
2. Enter 9 9 2. The VCR key will blink twice.
3. Press AUD once, then press VCR once. The VCR
key will blink twice.
The VCR key is now ready to be programmed for your
second audio device. See "Programming Device
Control" on page 10. To re-assign other device keys,
repeat these and substitute the key sequence using the
following chart:
NOTE: Only one device can be assigned to an unused
device key at a time.
To Re-Assign
VCR as 2nd VCR SETUP 9 9 2 AUD VCR
AUD key
VCR as 2nd VCR SETUP 9 9 2 TV VCR
TV key
VCR as 2nd VCR SETUP 9 9 2 CBL VCR
CBL key
VCR back to VCR SETUP 9 9 2 VCR VCR
VCR
www.urcsupport.com/atlasocap
Perform Key Sequence
21